Edemco Mica Heating Element R2007 for F2002-2 Dryer View larger

Edemco Dryer Heating Element for F2002-2 Dryer

R2007

More info

The R2007 replacement Heating Element is for the Edemco dryer F2002-2 only.

How to test your dryer for non working parts

If the dryer is not heating it does not mean the heating element is bad.

Heating Element and Thermostat:
The heating element and the thermostat can be tested with a continuity meter.

Pot Control:
The Pot Control can be tested with an ohm meter.  Turned all the way up it should read between 200 – 250 ohms.

Triac and PC Board:
The Triac and PC Board take special machines to test them.  Most of the time it will be the Triac that is bad.  You can pull back the black plastic on the PC Board to see if the board looks burnt. 

There are no guarantees since we do not have the parts to test them.

If you do replace the Triac the wires do have to be solder back on not twisted with caps or tape.  The Triac also has to be screwed back down to the heat sink before testing the parts.  If these instructions are not followed the Triac will arc and go out again.


Product Images and Descriptions Disclaimer

The product images and descriptions on our website may not reflect the actual configuration of the product. As we try to keep all product images and descriptions as closely correct as possible to match the product itself, at times inaccuracies may occur.

Actual product images and descriptions may vary due to product enhancements and/or changes that have not been updated to date.

We do not provide any guarantee as to the accuracy, completeness or suitability of the images and descriptions shown of our products. You acknowledge that such information and materials may contain inaccuracies or errors and we expressly exclude liability for any such inaccuracies or errors to the fullest extent permitted by law.

Accessories